How to: Replace a PS/2 mouse.
Solution:
Turn off the computer, disconnect the old mouse, connect the new mouse to a PS/2 port, and turn on the computer.
NOTE: Install a PS/2 mouse driver if necessary.
1) Shut down Windows 95, and turn off the computer.
2) Unplug the old mouse from the PS/2 port at the back of the computer.
3) Connect the new mouse to the same PS/2 port used by the old mouse.
4) Turn on the computer.
NOTE: If the new mouse is fully compatible with old mouse, Windows 95 should detect and configure the new mouse using the installed mouse driver.
5) If the mouse was not auto-detected, install the mouse driver.
NOTE 1: The following steps assume that you are replacing a PS/2 mouse with a new PS/2 mouse.
NOTE 2: The mouse installation disk may include a program that will 'test' the mouse installation (typically named test.com). Refer to the mouse installation manual for detailed configuration information.
